The libpixyusb library provides a software application programming interface (API) for communicating
with Pixy over USB. The following procedure will outline the steps to build libpixyusb as a Python module.

This procedure assumes the following:

• Your system is Linux (with Debian package manager)
• Pixy firmware has been update to 1.0.2
• Your system is connected to the internet

Instructions for updating the Pixy firmware are here: Uploading New Firmware

Start a terminal application.

In a terminal window type:

# sudo apt-get install swig

In the terminal window type:

sudo apt-get install libusb-1.0-0-dev

In the terminal window type:

sudo apt-get install g++

In the terminal window type:

sudo apt-get install libboost-all-dev

In the terminal window type:

git clone https://github.com/charmedlabs/pixy.git

In the terminal window type:

cd pixy/scripts
./build_libpixyusb_swig.sh

Make sure your Pixy is connected to a USB port on your computer. Then in the terminal window type:

cd ../build/libpixyusb_swig
python get_blocks.py

If all goes well, you should see blocks:

Pixy Python SWIG Example -- Get Blocks
[BLOCK_TYPE=0 SIG=1 X=220 Y= 17 WIDTH= 43 HEIGHT= 35]
[BLOCK_TYPE=0 SIG=1 X=220 Y= 23 WIDTH= 42 HEIGHT= 47]
[BLOCK_TYPE=0 SIG=1 X=220 Y= 23 WIDTH= 42 HEIGHT= 47]
[BLOCK_TYPE=0 SIG=1 X=220 Y= 23 WIDTH= 42 HEIGHT= 47]
[BLOCK_TYPE=0 SIG=1 X=220 Y= 23 WIDTH= 42 HEIGHT= 46]
[BLOCK_TYPE=0 SIG=1 X=220 Y= 23 WIDTH= 45 HEIGHT= 46]
[BLOCK_TYPE=0 SIG=1 X=219 Y= 23 WIDTH= 43 HEIGHT= 46]