This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:v2:uploading_new_firmware [2018/06/06 20:13] pixycam [The Next Time You Upload Firmware] |
wiki:v2:uploading_new_firmware [2018/06/06 20:40] pixycam [Uploading New Firmware] |
||
---|---|---|---|
Line 3: | Line 3: | ||
- | ====== Uploading New Firmware ====== | + | ====== Uploading new firmware ====== |
Pixy2 uses a ROM-based algorithm to upload new firmware into flash memory over USB, which makes Pixy2 "unbrickable" - that is, you will //always// be able to recover Pixy2 from an unsuccessful firmware upload or a "bad" version of firmware. | Pixy2 uses a ROM-based algorithm to upload new firmware into flash memory over USB, which makes Pixy2 "unbrickable" - that is, you will //always// be able to recover Pixy2 from an unsuccessful firmware upload or a "bad" version of firmware. | ||
Line 54: | Line 54: | ||
- | ==== PixyMon ==== | + | ==== What you should see ==== |
In the PixyMon console (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. | In the PixyMon console (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. |