wiki:v2:uploading_new_firmware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
wiki:v2:uploading_new_firmware [2018/06/06 20:12] pixycam [PixyMon] |
wiki:v2:uploading_new_firmware [2018/06/06 20:13] pixycam [PixyMon] |
||
|---|---|---|---|
| Line 54: | Line 54: | ||
| - | ==== PixyMon ==== | + | ==== What you should see ==== |
| In the PixyMon console (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. | In the PixyMon console (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. | ||
| Line 63: | Line 63: | ||
| - | ==== The Next Time You Upload Firmware ==== | + | ==== The next time you upload firmware ==== |
| The next time you upload firmware, the drivers will be installed, so you just need to initiate firmware upload mode by holding down the button while plugging in the USB cable. | The next time you upload firmware, the drivers will be installed, so you just need to initiate firmware upload mode by holding down the button while plugging in the USB cable. | ||
wiki/v2/uploading_new_firmware.txt ยท Last modified: 2018/06/06 20:40 by pixycam
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
