wiki:v2:uploading_new_firmware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wiki:v2:uploading_new_firmware [2018/05/28 13:25] pixycam [Windows Vista, 7, or 8] |
wiki:v2:uploading_new_firmware [2018/06/06 20:12] pixycam [PixyMon] |
||
|---|---|---|---|
| Line 56: | Line 56: | ||
| ==== PixyMon ==== | ==== PixyMon ==== | ||
| - | In the PixyMon command/status window (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. | + | In the PixyMon console (at the bottom of the PixyMon window) you should see the message "Pixy programming state detected". If you don't see this message, the drivers may still be installing. Just wait a little more. |
| Then a file selection dialog will appear. Browse to your new firmware file (it's a .hex file) and select it, then press **OK**. Pixy2 will then take the new program and write it into its flash memory. It's quick -- it only takes 5 seconds or so. When it's done uploading the new firmware will start running. | Then a file selection dialog will appear. Browse to your new firmware file (it's a .hex file) and select it, then press **OK**. Pixy2 will then take the new program and write it into its flash memory. It's quick -- it only takes 5 seconds or so. When it's done uploading the new firmware will start running. | ||
wiki/v2/uploading_new_firmware.txt ยท Last modified: 2018/06/06 20:40 by pixycam
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
