This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:v2:porting_guide [2019/02/01 15:25] pixycam |
wiki:v2:porting_guide [2019/02/01 15:44] pixycam |
||
---|---|---|---|
Line 37: | Line 37: | ||
- | {{wiki:v2:image_380.png}} | + | {{wiki:v1:image_743.png}} |
Line 46: | Line 46: | ||
* analog/digital x - this will output the x value of the largest detected object as an analog value between 0 and 3.3V on pin 8. It also outputs whether an object is detected or not as a digital signal (pin 1 of the I/O connector). | * analog/digital x - this will output the x value of the largest detected object as an analog value between 0 and 3.3V on pin 8. It also outputs whether an object is detected or not as a digital signal (pin 1 of the I/O connector). | ||
* analog/digital y - this will output the y value of the largest detected object as an analog value between 0 and 3.3V on pin 8. It also outputs whether an object is detected or not as a digital signal (pin 1 of the I/O connector). | * analog/digital y - this will output the y value of the largest detected object as an analog value between 0 and 3.3V on pin 8. It also outputs whether an object is detected or not as a digital signal (pin 1 of the I/O connector). | ||
+ | * LEGO I2C - this is a special protocol for LEGO Mindstorms EV3 brick. | ||
Note, the USB interface and protocol is always enabled, while each of the interfaces above can only be enabled one at a time. | Note, the USB interface and protocol is always enabled, while each of the interfaces above can only be enabled one at a time. |