wiki:v2:pixy_zumo_howto
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
wiki:v2:pixy_zumo_howto [2018/08/27 13:24] pixycam |
wiki:v2:pixy_zumo_howto [2019/01/28 23:35] jfrench |
||
|---|---|---|---|
| Line 59: | Line 59: | ||
| | | ||
| After you assemble the Zumo base, run a simple Arduino program to test the motors and buzzer. Below is a simple Arduino program you can cut and paste into the Arduino IDE. Note, the files ZumoMotors.h and ZumoBuzzer.h are part of the Pixy2 Arduino library (found [[https://pixycam.com/downloads-pixy2/|here]]). Install the Pixy2 Arduino library if you haven't already. | After you assemble the Zumo base, run a simple Arduino program to test the motors and buzzer. Below is a simple Arduino program you can cut and paste into the Arduino IDE. Note, the files ZumoMotors.h and ZumoBuzzer.h are part of the Pixy2 Arduino library (found [[https://pixycam.com/downloads-pixy2/|here]]). Install the Pixy2 Arduino library if you haven't already. | ||
| + | |||
| + | |||
| + | It's easy to hook the Zumo motors up backwards. This program will help you determine if your Zumo is working correctly. If something isn't right, none of the Zumo demos will work! So it's good to give this test a whirl... | ||
| Line 182: | Line 185: | ||
| - | 3. With the robot on its "lift" (so it doesn't run off) hold the object directly in front of the robot, centered, about a foot from Pixy2's lens. Both of Zumo's treads should be moving forward. Move the object to the right. Zumo's left tread should accelerate. Move the object to the left. Zumo's right tread should accelerate. If one or more of the treads moves incorrectly or doesn't move at all, inspect the motor connections to Zumo's PCB, and use the Zumo test program (above) to better characterize how the motion is incorrect. | + | 3. With the robot on its "lift" (so it doesn't run off) hold the object directly in front of the robot, centered, about a foot from Pixy2's lens. Both of Zumo's treads should be moving forward. Move the object to the right. Zumo's left tread should accelerate. Move the object to the left. Zumo's right tread should accelerate. If one or more of the treads moves incorrectly or doesn't move at all, inspect the motor connections to Zumo's PCB, and use the Zumo test program (above) to better characterize how the motion is incorrect. |
wiki/v2/pixy_zumo_howto.txt ยท Last modified: 2019/02/15 21:37 by jfrench
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
