wiki:v2:mounting_pixy_with_lego
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
wiki:v2:mounting_pixy_with_lego [2019/01/30 20:25] pixycam |
wiki:v2:mounting_pixy_with_lego [2019/01/30 20:27] pixycam |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| \\ | \\ | ||
| 4. Slide the Pixy2 into the brick assembly. It should fit nice and snug! Use two of the **medium fasteners**, and insert them from the inside as shown in the picture.\\ | 4. Slide the Pixy2 into the brick assembly. It should fit nice and snug! Use two of the **medium fasteners**, and insert them from the inside as shown in the picture.\\ | ||
| - | {{wiki:img:9f58a7327757cbb7950b00c046594788b98e3104.jpg?400}} | + | {{wiki:v1:img_5332_result.jpg?400}} |
| \\ | \\ | ||
| \\ | \\ | ||
| The fasteners form an axle that you can use to tilt Pixy2 up and down. Inserting the screws from the inside allows you to tighten them down, so Pixy2 holds the desired tilt angle.\\ | The fasteners form an axle that you can use to tilt Pixy2 up and down. Inserting the screws from the inside allows you to tighten them down, so Pixy2 holds the desired tilt angle.\\ | ||
| - | {{wiki:img:4ef644598e54018a30718786b257b64ee3932b80.jpg?400}} | + | {{wiki:v1:img_5335_result.jpg?400}} |
wiki/v2/mounting_pixy_with_lego.txt ยท Last modified: 2019/01/30 20:27 by pixycam
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
