This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
wiki:v2:interface_pane [2018/06/05 21:37] pixycam [Interface tab] |
wiki:v2:interface_pane [2018/06/05 21:37] pixycam [Interface tab] |
||
---|---|---|---|
Line 23: | Line 23: | ||
* **UART baudrate:** sets the baud rate if the **Data out port** is set to UART. | * **UART baudrate:** sets the baud rate if the **Data out port** is set to UART. | ||
- | * **Pixy 1.0 compatibility mode:** Pixy2 uses a different serial protocol than the original Pixy. The new protocol is simpler and supports multiple modalities, but if you want to use Pixy2 with your original Pixy Arduino programs, you can enable this parameter and Pixy2 will switch to the original Pixy serial protocol. Note, this parameter only applies to SPI, UART, and I2C interfaces -- not USB. Additionally, it only applies to the _color\_connected\_components program. | + | * **Pixy 1.0 compatibility mode:** Pixy2 uses a different serial protocol than the original Pixy. The new protocol is simpler and supports multiple modalities, but if you want to use Pixy2 with your original Pixy Arduino programs, you can enable this parameter and Pixy2 will switch to the original Pixy serial protocol. Note, this parameter only applies to SPI, UART, and I2C interfaces -- not USB. Additionally, it only applies to the _color\_connected\_components_ program. |