This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
wiki:v2:building_the_libpixyusb_example_on_linux2 [2018/06/29 14:37] hohenheim [3.1. hello_pixy: A Simple IO Example] |
wiki:v2:building_the_libpixyusb_example_on_linux2 [2018/06/29 14:38] hohenheim [3.1. Color Identification Example (GetBlocksCPPDemo)] |
||
---|---|---|---|
Line 70: | Line 70: | ||
The example does the following: | The example does the following: | ||
- | - Connects to Pixy using USB | + | - Connects to Pixy2 using USB |
- | - Displays firmware version installed on Pixy | + | - Displays firmware version installed on Pixy2 |
- | - Block information is displayed (as shown in the image above) if color signatures have been set and if the signatures are currently being detected by Pixy. | + | - Block information is displayed (as shown in the image above) if color signatures have been set and if the signatures are currently being detected by Pixy2. |