Differences

This shows you the differences between two versions of the page.

--- wiki:v2:assembling_pantilt_mechanism [2018/10/24 21:17]
pixycam
+++ wiki:v2:assembling_pantilt_mechanism [2018/10/24 21:28]
pixycam
@@ Line 142: / Line 142: @@
-- Attach the base to the pan servo as shown.
+ - Peel the backing off of the pan-tilt base.
+{{wiki:v2:img_5180_result.jpg?640}}
+- Use a round servo horn and line it up on either of the two possible positions on the pan-tilt base.  You may prefer to mount the servo-horn centered if you are just using the pan-tilt mechanism on a desktop (for example), or you may prefer to mount the servo-horn off-center if you plan on mounting the pan-tilt mechanism on a robot.  The off-center position allows Pixy2 to look over the edge of the base more effectively.
+{{wiki:v2:img_5183_result.jpg?640}}
+{{wiki:v2:img_5184_result.jpg?640}}
+- Use the short tapping fastener to mount the round servo horn to the pan-tilt base as shown.
+{{wiki:v2:img_5186_result.jpg?640}}
+- Use the four nylon stand-offs and four 2-56 fasteners to attach the stand-offs to the pan-tilt base as shown.
+{{wiki:v2:img_5191_result.jpg?640}}
+{{wiki:v2:img_5194_result.jpg?640}}
+ - Attach the base to the pan servo as shown.
 {{wiki:v2:img_5216_result.jpg?640}}
  - Use the servo horn fasteners (found in the servo baggies) to attach the tilt and pan servo horns.
 {{wiki:v2:img_5218_result.jpg?640}}
 {{wiki:v2:img_5222_result.jpg?640}}
  - The base plate has two hole patterns for attaching the standoffs: a rectangular hole pattern that we showed above and an Arduino hole pattern if you want to mount your Pixy pan-tilt on top of an Arduino.  If you wish to mount your Pixy pan-tilt on top of an Arduino, see below.
 {{wiki:v2:img_5228_result.jpg?640}}
 {{wiki:v2:img_5230_result.jpg?640}}

Documentation

User Tools

Site Tools

Differences

Page Tools