Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== Pixymon Configuration Parameters ======
+  * Max blocks
+    * Sets the maximum total blocks sent per frame.
+    * default: 1000
+  * Max blocks per signature
+    * Sets the maximum blocks for each color signature sent for each frame.
+    * default: 1000
+  * Min block area
+    * Sets the minimum required area in pixels for a block. Blocks with less area won't be sent.
+    * default: 20
+  * Min saturation
+    * Sets the minimum allowed color saturation for when generating color signatures. Applies during teaching.
+    * default: 10.0
+  * Hue spread
+    * Sets how inclusive the color signatures are with respect to hue. Applies during teaching.
+    * default: 1.0
+  * Saturation spread
+    * Sets how inclusive the color signatures are with respect to saturation. Applies during teaching.
+    * default: 1.0
+  * Data out port
+    * Selects the port that's is used to output data. 0=SPI, 1=I2C, 2=UART, 3=analog/digital x, 4=analog/digital y
+    * default: 0
+  * I2C address
+    * Sets the I2C address if you are using I2C data out port.
+    * default: 0x54
+  * UART baudrate
+    * Sets the UART baudrate if you are using UART data out port.
+    * default: 19200
+  * Default program
+    * Selects the program number that's run by default upon power-up.
+    * default: 0
+  * Brightness
+    * Sets the average brightness of the camera, can be between 0 and 255.
+    * default: 80

Documentation