<< return to Pixycam.com

User Tools

Site Tools


wiki:v1:my_pantilt_is_acting_sort_of_crazy

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
wiki:v1:my_pantilt_is_acting_sort_of_crazy [2018/08/22 22:17]
jfrench updated support email
wiki:v1:my_pantilt_is_acting_sort_of_crazy [2018/12/26 20:40]
jfrench added try unplugging one servo
Line 11: Line 11:
  
 If you are powering Pixy through the Arduino cable instead of through the USB cable, or the [[wiki:​v1:​Powering_Pixy|power connector]],​ the servos are not going to get enough power. This is because the Arduino typically can't source enough current for the servos (1 Amp), and the Arduino cable tends to drop significant voltage. There are more details [[wiki:​v1:​Powering_Pixy|here]] on using the power connector, which is recommended in this case. If you are powering Pixy through the Arduino cable instead of through the USB cable, or the [[wiki:​v1:​Powering_Pixy|power connector]],​ the servos are not going to get enough power. This is because the Arduino typically can't source enough current for the servos (1 Amp), and the Arduino cable tends to drop significant voltage. There are more details [[wiki:​v1:​Powering_Pixy|here]] on using the power connector, which is recommended in this case.
 +
 +One way to check if you have a power issue: if you connect only one servo - that is, try unplugging one - does the issue persist?
 +
 +If unplugging a servo solves it, that would point to current draw beyond the capabilities of your USB port or cable.
  
  
wiki/v1/my_pantilt_is_acting_sort_of_crazy.txt ยท Last modified: 2018/12/26 20:40 by jfrench