This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
wiki:v1:my_pantilt_is_acting_sort_of_crazy [2018/07/17 00:17] jfrench [My pan/tilt is acting sort of crazy] |
wiki:v1:my_pantilt_is_acting_sort_of_crazy [2018/08/22 22:17] jfrench updated support email |
||
---|---|---|---|
Line 55: | Line 55: | ||
rcs_setPos 1 0 | rcs_setPos 1 0 | ||
</code> | </code> | ||
- | This should exercise the pan servo first then the tilt servo. The movement should be smooth and rapid. If not, make a note of which servo is acting strange. and send us an email describing your experience (<support@charmedlabs.com>). | + | This should exercise the pan servo first then the tilt servo. The movement should be smooth and rapid. If not, make a note of which servo is acting strange. and send us an email describing your experience (<support@pixycam.com>). |
===== 9. Reduce the frequency ===== | ===== 9. Reduce the frequency ===== | ||
- | From PixyMon, bring up the [[wiki:v1:Configure_Dialog|Configure Dialog]] (the gear icon). In the "Servo" tab change the "Servo Frequency" to a lower value, from 100 to 75 or 60 and see if that improves the behavior of your pan/tilt servos. This suggestion is somewhat experimental, so please [[mailto:support@charmedlabs.com|send us a note]] if this helps! You can select **Action➜Restore default parameters** to get back if it doesn't help. | + | From PixyMon, bring up the [[wiki:v1:Configure_Dialog|Configure Dialog]] (the gear icon). In the "Servo" tab change the "Servo Frequency" to a lower value, from 100 to 75 or 60 and see if that improves the behavior of your pan/tilt servos. This suggestion is somewhat experimental, so please [[mailto:support@pixycam.com|send us a note]] if this helps! You can select **Action➜Restore default parameters** to get back if it doesn't help. |