wiki:v1:building_the_pan_tilt_2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
wiki:v1:building_the_pan_tilt_2 [2018/01/10 20:27] jfrench added Pixy mod |
wiki:v1:building_the_pan_tilt_2 [2018/01/10 20:27] jfrench |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| Locate C25 and C26 on the back side of Pixy toward the right edge of the board. We need to short the two inner pads of C25 and C26:\\ | Locate C25 and C26 on the back side of Pixy toward the right edge of the board. We need to short the two inner pads of C25 and C26:\\ | ||
| - | {{:wiki:img:img_5054_web.jpg?400}} | + | {{:wiki:img:img_5054_web.jpg?500}} |
| Do this by placing your soldering iron and heating up the two inner pads of C25 and C26 while adding solder. The solder should easily bridge once enough solder has been added:\\ | Do this by placing your soldering iron and heating up the two inner pads of C25 and C26 while adding solder. The solder should easily bridge once enough solder has been added:\\ | ||
| - | {{:wiki:img:img_5060_web.jpg?400}} | + | {{:wiki:img:img_5060_web.jpg?500}} |
| The complete modification looks like this:\\ | The complete modification looks like this:\\ | ||
| - | {{:wiki:img:img_5062_web.jpg?400}} | + | {{:wiki:img:img_5062_web.jpg?500}} |
| OK, once that's done, you're ready for the... | OK, once that's done, you're ready for the... | ||
wiki/v1/building_the_pan_tilt_2.txt ยท Last modified: 2018/01/10 20:30 by jfrench
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
