wiki:v2:assembling_pantilt_mechanism
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
wiki:v2:assembling_pantilt_mechanism [2018/10/24 21:31] pixycam |
wiki:v2:assembling_pantilt_mechanism [2019/02/13 21:10] (current) jfrench |
||
|---|---|---|---|
| Line 92: | Line 92: | ||
| - | 14 - Plug the servo wires into Pixy's servo connector. The pan servo goes on the left-side of the connector; the tilt servo goes on the right-side of the connector. (Which is the tilt axis? It's the one that's held down by the cable ties.) | + | 14 - Plug the servo wires into Pixy's servo connector. Looking at the back of Pixy2, the pan servo goes on the left-side of the connector; the tilt servo goes on the right-side of the connector. (Which is the tilt axis? It's the one that's held down by the cable ties.) |
| {{wiki:v2:img_5176_result.jpg?640}} | {{wiki:v2:img_5176_result.jpg?640}} | ||
wiki/v2/assembling_pantilt_mechanism.txt ยท Last modified: 2019/02/13 21:10 by jfrench
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
