Differences

This shows you the differences between two versions of the page.

--- wiki:servo_pane [2017/11/23 03:06]
jfrench Imported by DokuWiki Advanced Plugin
+++ — (current)
@@ Line 1: / Line 1: @@
-====== Servo Tab ======
-This tab contains parameters for configuring the two RC-servo ports on Pixy. The port pinouts, as well as which port is which can be found [[wiki:Port_Pinouts|here]]. To bring up the Servo Tab, first bring up the Configure Dialog (click on the gear icon or select **File➜Configure**). Now select the **Servo** tab under **Pixy Parameters**.
-{{wiki:img:3cf3e01f3ad221366d74bb1d736cee26701be520.jpg?300}}
-  * **S0 lower limit:** This parameter sets the lower limit of servo 0.
-  * **S0 upper limit:** This parameter sets the upper limit of servo 0.
-  * **S1 lower limit:** This parameter sets the lower limit of servo 1.
-  * **S1 lower limit:** This parameter sets the upper limit of servo 1.
-  * **Servo frequency:** measured in Hz, this parameter sets the frequency of the PWM signal that controls both servos.
-Note: the lower limit values control how far clockwise the servos move, with more negative being farther clockwise. The upper limit values control how far counter-clockwise the servos move, with more positive being farther counter-clockwise.
-You can test the limits by issuing servo move commands from the command/status window. Hit the **stop** button and type in the following commands:
-  * "rcs_setPos 0 0" moves servo 0 to its clockwise limit
-  * "rcs_setPos 0 1000" moves servo 0 to its counter-clockwise limit
-  * "rcs_setPos 1 0" moves servo 0 to its clockwise limit
-  * "rcs_setPos 1 1000" moves servo 0 to its counter-clockwise limit

Documentation

User Tools

Site Tools

Differences

Page Tools