wiki:v2:powering_pixy
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wiki:v2:powering_pixy [2018/05/24 19:25] pixycam |
wiki:v2:powering_pixy [2018/05/24 22:13] pixycam [I/O connector] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| Note also, ribbon cables can drop. So it's unlikely you can power Pixy2 through the I/O connector via ribbon cable **and** have enough power left over for controlling RC servos. The voltage will drop too much across the ribbon cable. Nothing bad will happen, if you try this but the servo will likely malfunction. | Note also, ribbon cables can drop. So it's unlikely you can power Pixy2 through the I/O connector via ribbon cable **and** have enough power left over for controlling RC servos. The voltage will drop too much across the ribbon cable. Nothing bad will happen, if you try this but the servo will likely malfunction. | ||
| - | {{wiki:img:c38c5bf8e350433e686aca84ca8bab657844d78c.jpg?400}} | + | {{wiki:v2:image_248.jpg?640}} |
wiki/v2/powering_pixy.txt ยท Last modified: 2018/05/24 22:39 by pixycam
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
