This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:v2:assembling_pantilt_mechanism [2018/05/16 14:59] pixycam [Assembly] |
wiki:v2:assembling_pantilt_mechanism [2018/05/16 15:17] pixycam [Assembly] |
||
---|---|---|---|
Line 131: | Line 131: | ||
{{wiki:v2:img_5222_result.jpg?640}} | {{wiki:v2:img_5222_result.jpg?640}} | ||
- | 25 - If you want to mount your Pixy on top of an Arduino, the base has a hole pattern that matches the Arduino hole pattern. There are two ways to mount your Pixy pan-tilt. Shown below is one configuration with the Arduino I/O connectors facing downwards. | + | 25 - The base plate has two hole patterns for attaching the standoffs: a rectangular hole pattern that we showed above and an Arduino hole pattern if you want to mount your Pixy pan-tilt on top of an Arduino. If you wish to mount your Pixy pan-tilt on top of an Arduino, see below. |
{{wiki:v2:img_5228_result.jpg?640}} | {{wiki:v2:img_5228_result.jpg?640}} | ||
Line 140: | Line 140: | ||
{{wiki:v2:img_5226_result.jpg?640}} | {{wiki:v2:img_5226_result.jpg?640}} | ||
+ | 26 - You're done! | ||
- | + | What's next? [[wiki:v2:run_the_pantilt_demo|Run the pan-tilt demo]]. | |
- | + | ||
- | + | ||
- | + | ||
- | + | ||
- | + | ||