Differences

This shows you the differences between two versions of the page.

--- wiki:v2:assembling_pantilt_mechanism [2018/05/16 00:07]
pixycam [Assembly]
+++ wiki:v2:assembling_pantilt_mechanism [2018/05/16 15:12]
pixycam [Assembly]
@@ Line 116: / Line 116: @@
 - Plug a USB cable into Pixy to let Pixy power-up and "zero" the servos.
+{{wiki:v2:img_5212_result.jpg?640}}
+- Leave the USB cable plugged-in and attach the tilt servo horn to the tilt servo.  The servo horn and Pixy should be close to upright as shown.
+{{wiki:v2:img_5213_result.jpg?640}}
+- Attach the base to the pan servo as shown.
+{{wiki:v2:img_5216_result.jpg?640}}
+- Use the servo horn fasteners (found in the servo baggies) to attach the tilt and pan servo horns.
+{{wiki:v2:img_5218_result.jpg?640}}
+{{wiki:v2:img_5222_result.jpg?640}}
+- The base plate has two hole patterns for attaching the standoffs: a rectangular hole pattern that we showed above and an Arduino hole pattern if you want to mount your Pixy pan-tilt on top of an Arduino.  If you wish to mount your Pixy pan-tilt on top of an Arduino, see below.
+{{wiki:v2:img_5228_result.jpg?640}}
+{{wiki:v2:img_5230_result.jpg?640}}
+And here is another configuration with the Arduino and base plate flipped.
+{{wiki:v2:img_5226_result.jpg?640}}
+- You're done!
+What's next?

Documentation